There are many things involved in the renovation, today we are talking about the relevant information about the color steel sandwich panel decoration. How to install the color steel sandwich panel, you need to pay attention to when installing.
These two aspects are the introduction of Caigang sandwich panels that we bring to you today. We hope to help everyone.
Color steel sandwich panel installation steps
Step 1. It is common to carry plates during the installation of color steel sandwich panels. However, handling is also very demanding. Care should be taken to lift both ends simultaneously. This prevents damage to its surface oxide film.
When installing a wall panel, it is best to lift one board at a time. Fixtures should be selected for special fixtures. The general manufacturers will have such fixtures. Lift slowly and avoid unnecessary bumps.
Step 2. Generally, there are two ways to fix the color steel sandwich panel; we can use the self-tapping screws to pass through the wall panel to directly fix the sandwich panel on the sub-structure on the wall. We can also use the self-tapping screws to pass through the connecting pieces in this way to indirectly connect with the wall sub-structure. The installation must be performed according to the manufacturer's regulations.
Step 3. During the installation, it is also necessary to use weatherproof glue (glass glue). Note that it is necessary to maintain its tightness when using weatherproof glue to seal, so that it can effectively prevent dust and rain from leaking.
Step 4. For the end of the installation, we also need to check, after the installation is completed, we must from top to bottom, layer by layer to remove the wall surface protective film, and demolition layer by layer, demolition frame wallboard Can not be scratched or bruised, inspect and clean some of the adhesive and dust.
Color steel sandwich panel installation considerations
Precautions 1. Before installing the sandwich panel, check the material, type, size, performance, and core material of the sandwich panel, and check the concealed construction inside the clip wall and check whether the construction requirements can be met. .
Precautions 2. When the sandwich panel is installed, it should be provided with high-efficiency filter air outlets, lamps, heat-sensing smoke components, loudspeakers, and through-holes of doors, windows, and pipes. The hole around the hole must be flat, tight, clean, and not obtrusive. Dust, its gap is covered with non-combustible material, and the perimeter of the inspection mouth is also well sealed.
Matters needing attention 3. Plate and board plate joints should be uniform, the gap error of the board seam should be no more than 0.5 mm, the board seam application sealant evenly sealed, the sealing place should be smooth, smooth, slightly lower than the board surface, wallboard installation should be The installation of vertical shingles shall be horizontal, the surface of the board shall be flat, and the position shall be correct. The intersection between the wall and the ground, the wall and the ceiling, the wall and the wall, and the top shall have a reasonable structure to ensure the sealing and prevent cracking. The corners should be Rounded corners.
Matters needing attention 4. Plate installation verticality ≤ 1.5 mm, surface roughness ≤ 1.5 mm, between the board and the board, the difference between the height of the joint ≤ 1.0 mm, the surface of the board should be smooth, smooth, consistent color, the protection of the surface of the board Membrane should be intact, and then tear the membrane before handing over. After installation, the sheet should be protected against collision and damage to the board surface.
Although the installation of color steel sandwich panels may seem complicated, as long as we follow the above steps, step by step to practice, you can quickly get started. There are many issues that need attention in the installation, so everyone must be careful to implement it, so as to avoid accidental mistakes, affecting the results.